Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
may allow debris to enter the pump and cause
clogging or damage to the pump.
NOTE: If the in-tank filter is damaged or too dirty to
permit cleaning, replace with a new in-tank filter.
9. To re-install the in-tank filter, gently set it back
over the filter base in the bottom of the tank, and
slowly turn the filter clockwise until the locking
tabs on the filter base align with the grooves in
the filter. The in-tank filter will drop downward
approximately 1/8 in., when this happens.
10. Push down on the in-tank filter until it stops,
approximately another 1/4 in., then turn the
in-tank filter approximately 1/8 turn clockwise
until it stops.
NOZZLE FLOW CHART
NOTICE: RISK OF PROPERTY DAMAGE. Always turn flow control knob to low GPM setting (1–3)
when switching to a low flow nozzle.
NOTICE: RISK OF PROPERTY DAMAGE. Failure to abide by Nozzle Flow Chart recommendations
may result in a damaged pump and void warranty.
Nozzles Included with Product
NOTE: Pressure and Flow
may vary ~10%
Foaming (Black)
Low-Volume Narrow Fan (Yellow)
Low-Volume Wide Fan (Red)
High-Volume Wide Fan (Brown)
Jet Stream (Orange)
Brass Adjustable (Straight Stream)
Brass Adjustable (Full Cone)
High-Volume Foam (White)*
* Not Included
NOTE: All values represent spraying with water or similar viscosity liquid product.
18
Fig. 18
Variable Control Dial Setting
1
Flow
Pressure
Flow
(gpm)
(psi)
(gpm)
0.17
16
0.20
0.18
12
0.21
0.18
13
0.21
0.21
3
0.26
0.20
6
0.24
0.20
6
0.24
0.14
27
0.16
0.18
1.3
0.21
2
3
Pressure
Flow
Pressure
(psi)
(gpm)
(psi)
22
0.22
17
0.24
18
0.23
4
0.30
8
0.27
8
0.27
35
0.17
18
0.23
1
4
Flow
Pressure
(gpm)
(psi)
27
0.24
32
22
0.26
27
23
0.26
28
6
0.33
7
11
0.31
14
11
0.31
14
40
0.19
50
23
0.26
28
Publicidad
