Descargar Imprimir esta página

Grundfos Conex DIA-2 Instrucciones De Instalación Y Funcionamiento página 25

Ocultar thumbs Ver también para Conex DIA-2:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 104
Peculiarities for the connection at the control
panel enclosure of Conex
1. First connect the measuring cells, the single-rod
measuring chains and the water sensor (if present)
to the separate sensor interface.
2. Secondly, connect the sensor interface to the
®
Conex
DIA-2 control panel enclosure.
Connecting the sensor interface to the Conex
DIA-2 (see back side of device)
Measuring cells
AQC-D1/-D11/AQC-D2/-D12/AQC-D3/-D13/ HP
(peroxide)
Connect terminals 4/1 to 4/14 of the sensor
interface to the corresponding terminals of the
®
Conex
DIA-2.
Measuring cells HP (peroxide)
In addition, connect terminal A to terminal 1/1
and terminal B to terminal 1/2 of the Conex
DIA-2.
Single-rod measuring chains (pH)
Connect terminals 3/1 to 3/4 of the sensor
interface to the corresponding terminals of the
®
Conex
DIA-2.
Sample-water deficiency sensor
Connect terminal A to terminal 2/3 and terminal B
to terminal 2/4 of the Conex
When using measuring cell AQC-D2/-D12,
Note
the water sensor must always be
connected and activated!
DIP switch
If necessary, set the DIP switch for the desired
measured value to "On" (move the switch to the
right, top switch 1 is not used).
DIP
On
OFF
1
ClO
, O
2
2
3
4
Cl
2
Fig. 24
DIP switch
®
DIA-2
®
®
®
DIA-2.
3
25

Publicidad

loading