Descargar Imprimir esta página

Software Overview - Grundfos Conex DIA-2 Instrucciones De Instalación Y Funcionamiento

Ocultar thumbs Ver también para Conex DIA-2:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 104

11.3 Software overview

Provided that the code numbers for access
right have been set, some menus (and
submenus) as well as the functions Cal
Note
and Man are protected against
unauthorised access. The protected
menus are marked with "C" (calibration
rights) or "F" (full rights).
Main menus
Controller 1/2, see section
Alarm 1/2, see section
Service, see section
Service.
Setup, see section
Setup.
Function buttons
Cal, see section
Calibration function.
Man, see section
Manual operation.
Controller 1/2
"F" (full rights)
Setting the parameters
Relay 1/2
– setpoint
– controller parameters.
Continuous controller
– setpoint
– controller parameters.
Alarm 1/2
"F" (full rights)
Alarm settings
– alarm 1/2 values (switching points)
– effective direction
– hysteresis
– alarm delay.
Dosing time monitoring
– maximum dosing time (at constant dosing flow
level of 100 %).
Controller
1/2.
Alarm 1/2.
Service
Calibration logbook 1/2
– the last 10 calibrations.
Calling up the controller 1/2 settings
Test of functioning of current outputs
Test of functioning of relays
Test of functioning of display.
Setup
"F" (full rights)
Selecting language
Parameter 1/2: selecting measured values
Selecting measuring cell
Selecting measuring range
Configuration of controller 1/2
Switching on/off water sensor
Time setting
Code function
Display contrast
Calling up factory settings
Current output: assignment of current outputs to
measuring ranges
Calling up program version.
Calibration function
"C" (calibration rights)
Calibration of selected parameters
– chlorine, chlorine dioxide, ozone, peroxide, pH.
Manual operation
"C" (calibration rights)
Running the configured controllers manually.
29

Publicidad

loading