Publicidad
Using and Calibrating Float
Inside Float is a unique spring–powered counter–balance mechanism. When properly calibrated for the weight of the
desktop and its contents, you will be able to raise and lower the worksurface with ease.
To Raise and Lower Worksurface
1
Squeeze and hold the Release Paddle.
2
Raise and lower the worksurface
to your desired height. If table does
not raise up and down with ease, you
will need to calibrate your float.
Adjusting Counter-balance Tension
When you add/remove components from the worksurface, you may need to calibrate the counter balance mechanism.
If the worksurface is difficult to lift, increase the tension.
If the worksurface is difficult to lower, decrease the tension.
WARNING: Float will support a maximum weight of 130 lbs.(60 kg), including the worksurface. Please contact
Customer Service for information about our Float Heavy Duty kit which will increase capacity to 160 lbs. (70 kg).
With Mounted Tension Adjuster Handle
1
If you have a Mounted Tension Adjuster Handle, unfold the handle.
2
Rotate your Mounted Tension Adjuster Handle. Working in increments using the indicator window as a reference until your
table adjusts with ease. Rotating clock-wise increases the tension (2a) and rotating counter clock-wise decreases the
tension (2b).
Pay attention to the red needle in the Indicator Window to ensure that you do not adjust the tension beyond the Min
or Max markings.
1
2a
1
2
2b
11
Publicidad
