Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING：The prophy head should be cleaned and lubricated on a regular basis.
To polish, follow the steps below:
1.
Place a rubber cup on the prophy head and put paste in the cup to begin polishing.
2.
Press the Micro-motor (mode) button to switch from scaling to polishing mode
3.
Adjust the Oscillating dial to a low speed, 2,000 rpm.
4.
Press on the foot switch to engage the polishing hand piece and begin polishing.
5.
Add paste as needed.
Assembling the Scaler Unit
a.
Ensure that the power switch is set to off. If plugged in, the power indicator light should not
be lit.
b.
Plug the power cord of the main unit into a grounded AC power outlet.
c.
Insert the tip into the hand piece and lock it into place by using the enclosed plastic wrench.
Be careful not to overturn the tip as it may cause the tip and hand piece to break.
d.
Ensure that the water tube connection to the water supply source and main unit is secure.
- 17 -
Publicidad
Solución de problemas
