Turning On And Off; Shutdown And Hardware Reset; Charging The Battery Via The Usb Cable - Mio Moov M300 Serie Manual Del Usuario

Turning on and off

For normal operation, turn off your Mio by sliding the power switch to the OFF position. Your Mio enters a
suspended state. To use it again, slide the power switch to the ON position. Your Mio will be back to where
you left off.
Moov M300-Series

Shutdown and hardware reset

Occasionally, you may need to perform a hardware reset when your Mio stops responding; or appears to be
"frozen" or "locked-up."
You can perform a hardware reset by shutting down your Mio and then turning it back on. To shut down
your Mio, slide the power switch to the RESET position. To turn on your Mio after shutting it down, slide the
power switch to the ON position.
Note: Switching to the Reset position turns the battery off. It is recommended you move the switch to this position
if you are planning to store your Mio for any length of time.

Charging the battery via the USB cable

If you intend to charge your Mio in this way, turn off your Mio so that it takes less time to charge the
battery.
1. Turn on the computer.
2. Connect the mini-USB end of the USB cable to the
USB port on your computer.
Note: If your Mio is on when connected to a computer, a screen appears to prevent you from using your Mio.
Moov M400-Series
bottom of your Mio and the other end to a
11