Product Mounting Diagram; Lens Tubes - Chauvet Professional OVATION E-910FC IP Guía De Referencia Rápida

EN
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our Chauvet line of mounting clamps, go to
http://trusst.com/productcategory/truss-clamps/.

Product Mounting Diagram

Lens Tubes

The following lens tubes are available for purchase:
• 19°, 26°, 36°, and 50° w/Gel frame (6.25 in/159 mm accessories)
• 14°, 15°–30°, and 25°–50° Zoom Gel frame (7.5 in/191 mm accessories)
Passcode
After being prompted, enter the following passcode by pressing: <UP>, <DOWN>, <UP>, <DOWN>, <ENTER>.
This passcode cannot be changed and must be used whenever prompted.
Soft Focus Filter
The Ovation E-910FC IP comes with a soft focus filter. To keep the soft focus filter in good condition:
• Ensure that no fingerprints are left on the filter, as this may cause the filter to heat unevenly and eventually warp.
• When placing the filter in the holder, follow the orientation direction printed on the filter.
• When inserting shutter blades into the light path, note that the heat is reflected back at the filter. The deeper the
blades are inserted, and the longer the fixture runs, the more heat gets reflected on to the filter, causing it to warp
and potentially adhere to the shutter blades.
If there is a protective film on the soft-focus filter, it must be removed before use. The filter is in a
holder in the metal gobo slot.
3
QUICK REFERENCE GUIDE
Safety Notes. Use at least one mounting point per product. Make sure the
Ovation GR-1 IP
power/signal output
Overhead Mounting
Mounting clamp
Safety cable
Secure the safety cable using
the passageway on the top of
the product
Alternate yoke
attachment
Ovation E-910FC IP QRG Rev. 11