Switching The Clipper On And Off; Using The Clipper; Replacing The Clipping Blades - Heiniger Xplorer Pro Traducción Del Manual Original

NOTE!
If the clipping pressure is too low, hair can gather between the clipping blades. This
results in a poor clipping quality. In this case, clean the clipping blades as described
in chapter 6.11.
6.7

Switching the clipper on and off

Fig. 10 Switch in
OFF-position ("0")
Machine off
6.8

Using the clipper

Approach the animal from the front.
X
Secure the animal to be clipped and calm it down.
X
Switch the clipper on while you are in the visual range of the animal.
X
Observe the animal's behaviour while clipping.
X
Switch the clipper off after you have finished clipping.
X
6.9

Replacing the clipping blades

Fig. 13
Fig. 14
Fig. 15
14
Fig. 11 Switch in
ON-position ("I")
Machine lower level
Switch the clipper off by sliding the switch to the po-
X
sition "0".
Turn the adjusting knob in the direction of the arrow
X
until the resistance decreases.
Place the clipper with the comb plate screws facing
X
upwards on a flat surface.
Loosen the comb plate screws and remove the clip-
X
ping blades.
NOTE!
X
Translation of the original instructions / Cattle and horse clipper
Fig. 12 Switch in
Make sure the clipping blades are positioned
correctly when installing the new or sharpen-
ed blades.
ON-position ("II")
Machine faster level