Publicidad
Idiomas disponibles
Idiomas disponibles
Malfunction
No speed difference
between level I and
level II
Lowest LED on charger
is not lit.
Normal charging does
not start when the
discharged battery is
inserted.
Bottom LED lights up
green.
Top LED lights up red.
8
Spare parts
See spare parts list at the end of these operating instructions.
CAUTION!
FAULTY SPARE PARTS MAY CAUSE DAMAGES, MALFUNCTIONS OR TOTAL
LOSS AND MAY REDUCE SECURITY.
Use only original spare parts from the manufacturer. Obtain spare parts from an
X
authorised dealer or directly from the manufacturer.
NOTE!
If non-approved parts are used, all warranty, service, compensation and liability claims
against the manufacturer or its employees, dealers and representatives will be forfeit-
ed.
During the warranty period the device must be opened only by personnel authorised by the man-
ufacturer, otherwise the warranty will be void.
Pos.
Description
No.
Clipping head complete without
1
blades
2
Tension nut cattle
3
Distance screw
4
Tension sleeve
5
PH screw M5x14
6
Clipper head case
7
Pressure spring
8
Pressure plate
9
Eccentric square
18
Cause
Faulty motor and / or electronics
Charging station is not connected
to the power supply.
Electronics or power supply unit
defective.
Battery terminals and/or charger
are dirty.
Faulty battery.
Electronics are defective.
Battery is deeply discharged, the
charger is trying to boost the batte-
ry voltage.
Faulty battery.
Quan-
tity
1
1
1
1
2
1
1
1
1
Translation of the original instructions / Cattle and horse clipper
Rectification
Notify customer service.
Connect the charging station
to the power supply.
Notify customer service.
Clean contacts.
Replace battery.
Notify customer service.
If it is successful, normal
charging starts. (Never store
batteries in the discharged
state).
If it is not successful, the lowe-
st LED lights up red (see the
following table).
Replace battery.
Pos.
Description
No.
31
Switch lever
32
Catch spring with contact
33
Lower housing cover
34
Motor holder
36
Li-Ion battery 10.8 V / 2.85 Ah
37
PCB clipper
38
Switch contact
39
Countersunk head screw Torx
Kaflok M3x6
40
Top housing shell, complete
Quan-
tity
1
1
1
1
1
1
1
2
1
Publicidad
Solución de problemas
