Husky MP180 Guía De Uso Y Cuidado página 11

Operation Instruction – STICK/TIG Mode (Continued)
3
Setting Up for STICK Welding
□
Double check your input voltage:
For 120V: Switch voltage switch (Q) to 120V, use a 240V to
120V adapter while connecting to the 120V power source.
For 240V: Switch voltage switch (Q) to 240V, connect to 240V
power source.
□
Check the electrode packaging to determine the
recommended polarity.
□
For direct current electrode positive (DCEP) or direct current
reverse polarity (DCRP) welding process, plug ground clamp
into negative (-) DINSE socket (M) while plug electrode holder
into positive (+) DINSE socket (N). Most electrodes use DCEP.
□
Check whether the ground clamp has a good connection to
the workpiece and ensure workpieces are clean and dry (not
rusty, painted or oily).
□
Clamp the welding electrode with electrode holder.
□
Switch the ON/OFF power switch (O) to ON at the back of the
machine.
□
Push the welding mode switch button (K) until the STICK LED
turns on.
□
Set the welding current by rotating the left knob (E). If
needed, rotate the middle knob (D) to adjust your hot start
current.
STICK Welding Setting Chart
Electrode Electrode
Type Diameter
E6010
E6011
E6013
E7018
`
11
Please contact 1-888-43-HUSKY for further assistance.
Amp
(120V)
70A
3/32 in.
-
1/8 in.
5/32 in. -
1/16 in. 40A
40-70A
3/32 in.
1/8 in. -
5/32 in. - 130-170A
3/32 in. 70A
1/8 in. - 110-150A
-
5/32 in. 140-170A
HUSKYTOOLS.COM
Amp
(240V)
50-70A
75-130A
90-170A
40A
40-70A
80-140A
70-110A