Window Slider Kit Installation - Black and Decker BPT05WTBA Manual De Instrucciones

SET UP & USE

WINDOW SLIDER KIT INSTALLATION

Your window slider kit has been designed to fit most standard "Vertical" and
"Horizontal" window applications; however, it may be necessary for you to
improvise/modify some aspect of the installation procedures for certain types of
window. Minimum and maximum window openings:
MAXIMUM : 50" (127 cm)
NOTE: · A plastic locking screw is holding the window slider kit together during shipment.
Prior to installation, remove the locking screw, adjust to desired length and use
provided locking screw to secure.
NOTE: · If the window opening is less than 20.5" the minimum length of the window slider
kit, cut the one with a hole in it short to fit for the window opening. Never cut out
the hole in window slider kit.
Horizontal Window
DOUBLE-HUNG SASH/SLIDING CASEMENT
WINDOW INSTALLATION
1. Cut the foam seal (adhesive type)
to the proper length and attach it
to the window sash.
2. Attach the window slider kit to the
window sash. Adjust the length of
the window slider kit according to
the width of window. Shorten the
adjustable window kit if the width
of window is less than 20.5".
3. Cut the foam seal (adhesive type)
to the proper length and attach it
on the top of the window.
4. Close the window securely against
the window slider kit.
5. Secure the window slider kit to the
window sash.
6. Cut the foam seal to an
appropriate length and seal the
open gap between the top window
frame and outer window frame.
MINIMUM : 20.5" (52 cm)
Vertical Window Window Slider Kit
Foam
Seal
Window Sash
Window
Slider Kit
Window
Slider Kit
Foam
Seal
Window slider kit can be secured
by inserting the locking screw
Cut on opposite
side of hole.
Locking
screw
Foam
20.5"~50"
Window
Slider Kit
Window
Slider Kit
Foam
Page 11
Seal
Seal