Black and Decker BPT05WTBA Manual De Instrucciones página 19

SET UP & USE
TO OPERATE TURBO
• Press the Function
screen then press the function
symbol will stop flashing and will illuminate on the LED screen
indicating that TURBO is activated.
TO CANCEL TURBO
• Press the Function
the function
no longer be illuminated in the LED screen indicating that TURBO function is
deactivated.
FOLLOW ME
Parts of the room are cooler where there is a draft. Other parts are warmer due
to direct sunlight. The FOLLOW ME Function allows the room to be cooled
according to the room temperature, wherever the remote is located.
• This function can be activated from the remote control ONLY. The remote
control serves as a thermostat allowing for the precise temperature control at
its location.
• To activate the Follow Me function, point the remote control towards the
appliance and press the FUNCTION
• Press either the
the LED screen.
• Press the Menu
on the LED screen.
• The remote will display the actual temperature at its location. The remote
control will send this signal to the air conditioner at 20 minute intervals.
• If the unit does not receive the Follow Me/Temp Sensing signal during a 25
minutes interval, the follow me function will be canceled and will need to be
reactivated.
NOTE: · The remote must be within 23 feet of the remote control receiver on the
air conditioner unit. It should not have any obstructions.
• To cancel this function, press the
until the flashes onscreen, and then press the
cancellation. The
button, TURBO
button, TURBO
button again, the TURBO
OR button until the FOLLOW ME
button. The FOLLOW ME
will stop flashing and disappear from the screen.
symbol flashes on
button again, the TURBO
symbol flashes on screen then press
symbol will stop flashing and will
button.
will stop flashing and illuminate
, then press either the
button to confirm the
symbol flashes on
or button
Page 19