Troubleshooting - RIDGID 760 FXP Manual De Instrucciones

Troubleshooting

SYMPTOM
Machine will not run.
Machine not able to
thread.
Die head does not start
threading.
Torn threads.
Out-of-round or crushed
threads.
Support device turns
while threading.
Thin Threads.
999-995-242.10_REV A
POSSIBLE REASONS
Battery is completely discharged or battery is no
longer functional.
Battery not properly inserted into handle of tool.
Tool has reached over temperature threshold.
Die Head Retaining Mechanism Open.
Dull dies.
Overload due to torn or out-of-round threads
Poor quality or insufficient thread cutting oil.
Insufficient voltage.
Die head not square with end of pipe.
Pipe end not squarely cut.
Dull or broken dies.
Machine running in wrong direction.
Dies set improperly in the die head.
Incorrect Die Type Used.
Damaged, chipped or worn out dies.
Improper or insufficient thread cutting oil.
Incorrect type of die for material.
Poor pipe material/quality.
Pipe wall thickness too thin.
Support arm jaws dirty.
Support arm not aligned properly.
Support arm not tight.
Dies not placed in proper order.
760 FXP Power Drive
SOLUTION
Insert fully charged battery/replace battery.
Check to assure battery is fully inserted.
Remove battery and allow tool to cool for 30 min-
utes before reattempting use.
Rotate die head by head to engage drive pawls
into spline and close retaining mechanism.
Replace dies.
See possible reasons below.
Use RIDGID Nu-Clear™, Endura-Clear™ or
®
Extreme Performance™ Thread Cutting Oil in ad-
equate quantity.
Check battery charge level and charge battery.
Push against Push Pad (for 12-R or 1½" -2" 11-R)
or cover plate of die head to start thread.
Cut the pipe end squarely.
Replace dies.
Check position of the Forward/Reverse Slide
Switch.
Ensure chasers are set outward against the
cover plate lugs.
Confirm that dies are in the correct position within
the die head.
Use RIDGID High-Speed Dies only.
Replace dies.
Only use RIDGID ® Nu-Clear™, Endura-Clear™
or Extreme Performance™ Thread Cutting Oil in
adequate quantity.
Select high-speed, stainless steel , or alloy dies
that are suitable for the application.
Use higher quality pipe.
Use schedule 40 or heavier wall thickness.
Clean with wire brush.
Align support arm squarely with the pipe.
Tighten feedscrew.
Place dies in proper die head slot.
15