First Steps And Use - auna Oxford SE Manual De Instrucciones

FIRST STEPS AND USE

Set the clock
In standby mode:
1. Short press the REPEAT button.
2. A '00:00' will now flash in the display. Short press the TUNE/SKIP
buttons to display the correct hour and then short press the PLAY button
to confirm.
3. The minute digits will then flash in the display. Short press the TUNE/
SKIP buttons to display the correct minutes and then short press the
PLAY button to confirm.
4. Your clock is now set and will be displayed in Standby mode.
Power on
Short press the Standby button. Your Retro Turntable will turn on, 'DAB' will
be displayed and your product will be in DAB mode.
Standby mode
This product is designed to go to Standby mode automatically after
15 minutes (approximately), if it does not receive an audio signal. Short
press the Power button to switch your product back on again.
Changing the source (mode)
Short press the SOURCE button to change between DAB, FM, CD, USB,
Aux in and Phono (Turntable) modes. Please check the display, which will
confirm the mode.
Adjusting the volume
Turn the large right hand rotary volume control clockwise to increase the
volume and anti-clockwise to decrease the volume.
Using headphones
You can connect headphones with a 3.5 mm plug (not included) to the
socket on the front of the Retro Turntable. When you have headphones
connected the speakers are switched off and all sound is via the
headphones.
Note: Always keep the volume within reasonable limits.
EN
39