Publicidad
Idiomas disponibles
Idiomas disponibles
Use the "SET" button to switch between the alarm and the time display.
Make sure the weather station displays the alarm time. This can be
recognized by the solid : between the hour and minute notation.
• Press the "SET" key and hold it for at least 3 seconds until the alarm time
hours start to flash.
• Press the "+" or "-" key to set the correct hour.
• Press the "SET" key to set the minutes.
• Press the "+" or "-" key to set the correct minutes.
• Press the "SET" key to exit the program mode or wait 10 seconds.
The alarm has been set. If the alarm function has been activated you will se
a bell icon in position 6 of the indoor screen.
To activate the alarm, press the "-" key.
To deactivate the alarm, press the "-" key.
When the alarm sounds, it will generate a beeping tone for 60 seconds.
After 1 minute, the alarm signal will stop and the alarm will be set for the next
alarm time in 24 hours.
Press any key to stop the alarm sooner.
• Do not place the indoor unit in direct sunlight and keep away from
heat-emitting objects. (lamps, heaters, etc.)
• To ensure proper reception of the radio-controlled time signals, do not
place the outdoor unit next to large metal surfaces or heavy electrical
appliances
• Depending on the local conditions, the range between the outdoor unit and
indoor unit will vary. Before mounting the outdoor unit permanently, check
for a constant connection between the outdoor unit and indoor unit. Then
mount the outdoor unit securely.
• The distance between the indoor and outdoor unit must not exceed 30
meters
•
RESETTING THE RAINFALL VALUE
The indoor unit displays the registered rainfall on the screen (8) + (2). The
mm/h value (8) is the accumulated value of the rain since the beginning of
measuring or the last reset. The graph (2) gives an overview of the hourly
rainfall over the last 12 hours.
To reset the rainfall value, press the MIN (-) button twice as described below.
•
Press the MIN (-) button once briefly for <1 second.
•
Immediately after releasing the button, press and hold the MIN (-)
button for 3 seconds.
The rain value is now set to 0 and the indoor unit is reconnecting
(Synchronizing) with the rain unit. Make sure the indoor unit is within 30
meters of the rain unit during synchronization.
PLACEMENT TIPS
-13-
Publicidad
