Descargar Imprimir esta página

Sulion BOMBAY L Manual De Instalación página 7

Ocultar thumbs Ver también para BOMBAY L:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
Do not throw away electrical products together
with household waste. We ask you to recycle the
packaging at the collection points provided for this
purpose. Contact local authorities or your provider
for recycling advice. Thank you for recycling at
the collection points provided for this manual.
Device technical spectifications
General
Nominal voltage and frequency
Protection category
Protection index
Work temperature
Maximun ceiling slope on which it can be installed
Weight
Power consumption in standby mode (W)
Service value measurement standard
Main LED
Wattage
Flux
Color temperature
RGB
Data measurement
12
Nº of ON/OFF cycles
Nº of hours of lifespan
Dimmable
Angle
CRI
This product have a light source of energy efficiency class
Fan
Speed
Power (W)
RPM
Airflow (m³/min)
Airflow (m³/h)
Max noise level (dB)
Service value SV ((m³ / min) / W)
Maximum air speed (m / sec)
CIF A28763647
Note: The important warnings and instructions indicated in
this manual are not guaranteed to cover all possible conditions
and situations that may occur. It must be understood that
common sense, precaution, and care are factors that cannot
be included in all products. These factors can and must only
be provided by the user who maintains and enjoys this fan.
220-240V~AC 50/60Hz
+34 916774540
Calle Verano, 51 - Polígono Industrial Las Monjas -28850 Torrejón de Ardoz - Madrid (ESPAÑA)
Preparing for installation
Note: The estimated installation time is 120 minutes. This
product can only be installed by a certified electrician Ca-
refully separate the fan's parts, avoiding the use of cutters
or blades that could scratch any part of it.
Remove the fan from the packaging carefully, avoiding the
use of knives which could scratch any part of it.
Remove all the components. Place the motor on a cloth or
wet surface so as not to damage its surface finish. Carefully
handle the unit to make sure that its casing does not bend
or get scratched.
Clase I
IP20
The fan must be mounted on the floor or a large enough
table to prevent any component from falling off.
-5
40ºC
15º
Instructions for synchronizing the
8,3Kg
receiver and the remote control
<0,5
The control is already factory-linked with its receive.
EN 62879:2020
Make sure all connections are correctly made.
Make sure that the remote control contains batteries.
Make sure that all switches (main and isolation) are on.
36W
The control of this fan have two mode of synchronization,
3300lm
Universal mode and Unit mode:
- Unit Mode:
3000/4000/6000K
This type of synchronization allows you to control two or
No
more nearby fans independently, each with its remote con-
360º Sphere
trol.
Synchronization:
10000
The control of this fan does not require synchronization
30000h
with the receiver, the control is already factory-linked with
No
its receiver
120º
- Universal Mode:
This type of synchronization allows you to control one or
>80
more nearby fans with the same remote control.
Synchronization:
E
1.-Connect the power (wall switch) of the fan or fans that
you want to control, and then just within the following
15 seconds, press the key
6
continuous seconds.
22
2.-Now, transmitter and receiver of the fan / s will have
220
been synchronized. Turn off the fan / s current using the
switch or automatic and then turn it back on / s, this step
172
is the one that closes the synchronization process.
10300
It is not possible for a controller to forget a fan once it has
38
been linked, if you want a fan to leave
7,81
to obey a command, another one must be linked to
"overwrite it".
3,18m/s
ATC: 916749481 - info@sulion.es / SAT : 916749483 - sat@sulion.es
Remote control
Turn off
the fan
Change
color
temperature
Speeds
*Timer: Se qualquer botão for premido depois de um pro-
grama de encerramento ter sido seleccionado, este será
cancelado.
Light color temperature change
You can change the color temperature of the light, turning
off and on, with the wall switch, the remote control or in
case of being an IoT fan from your terminal.
OFF
ON
of the remote control for 10
WARM
Memory function
WARM
WARM
Turn on/off
the light
Yellow
White
Blue
3
2
4
Summer
/Winter
1
5
6
Timer*
2H
4H
Nature wind
13
ON
NEUTRAL
OFF
COLD
OFF
ON
OFF
ON
NEUTRAL
OFF
ON
>20"
WARM
www.sulion.es

Publicidad

loading

Este manual también es adecuado para:

16946041694611217234721723852172361