Acetech iTracer Unit Manual De Instrucciones página 23

2-1-1 iTracer CD Operation Introduction
Data Knob (Pressable)
Under UP/DN mode (Count Up/Down) :
●
A. Rotate data knob clockwise/counterclockwise:
Adjust the brightness of OLED
B. Press and hold data knob for 2 seconds:
Reset the values of Count Up/Count Down
C. Press data knob 3 times consecutively:
Swap the multiple-round burst/ full auto mode.
(OLED will show "BURST" or "AUTO".)
Under SPD (Speed) Mode:
●
A. Rotate data knob clockwise/counterclockwise:
Inquire the last 25 records
B. Press and hold data knob for 3 seconds to remove all the past records.
C. Under SPD mode, you could not swap the multiple-round burst/ full auto
mode. The illuminating function of iTracer Unit will be temporarily turned
off as well. These functions will be resumed when you switch to other modes.
Under ROF Mode :
●
A. Rotate data knob clockwise/counterclockwise to inquire the last 25 records.
You may not swap the multiple-round burst/ full auto under this mode.
B. Press and hold data knob for 3 seconds to remove all the past records.
Under ST mode :
●
A. Rotate data knob clockwise/counterclockwise:
To select the functions you would like to adjust and set parameters.
B. Press data knob: Enter/Confirm.
Mode Selector : Knob for mode selection
ROF : Measure Rate of Fire and provide the last
●
25 records
SPD : Measure the Muzzle Velocity and Energy
●
and provide the last 25 records
DN : Count Down mode
●
UP : Count Up mode
●
: Power off
0
●
ST : Other functions and parameters setting
●
OLED screen : 128x32 pixel
EN
22
EN