Installing The Uv Bulb - Astralpool Lyriox UV-C Manual De Instalación Y Funcionamiento

INSTALLING THE UV BULB

1. Remove all packaging from the UV bulb (C).
2. Slide the UV bulb (C) carefully through the quartz sleeve (D) that you have
just fitted and tested, as per the instructions on pages 9 and 12.
3. While holding one of the black end caps (B) gently push the cable through the end cap
which will make it easier to fit the bulb socket (F) in step 5.
IMPORTANT: Do not pull the cable by holding just the bulb socket.
4. Fit the End Cap Flat Washer (I) over the bulb socket and locate it in the end cap so it
is seated on the inside lip of the end cap.
IMPORTANT: Ensure the end cap flat washer is not twisted and it remains in this
location throughout the installation.
5. In no particular order, align the
UV bulb pins with the holes in
the bulb socket and carefully
push the bulb socket firmly onto
the UV bulb pins. You may need
to hold the other end of the UV
bulb to help you fit the socket.
6. Ensure the UV bulb socket is
firmly connected to the UV bulb.
7. Repeat steps 3 to 6 at the other end of the unit.
8. Now at one end of the unit, slide the black end cap (checking that the flat washer in
position) over the bulb socket while carefully holding the cable to prevent the bulb
connector disconnecting from the UV bulb.
9. Screw this end cap onto the thread on the white locking nut (H) already connected to
the UV body. HAND TIGHTEN ONLY.
10. Repeat steps 8 and 9 at the other end of the unit.
11. Check that all of the fittings are hand tightened. No tools are needed.
12. On multiple bulb units, do not mix up the bulb connectors as this will result in the bulb
not illuminating.
Please ensure that there is enough space at one end of the UV to enable bulb / quartz
sleeve removal and maintenance.
ENGLISH
(B) (I) (F) (C)
14
(D) (H)