Publicidad
Pram Body
Fabric holder - Footrest
7.6 Place the fabric holder into the fabric lock and push the fabric towards the fabric holder.
7.7 When the fabric is on the fabric holder tip, push it forward in the fabric groove.
7.8 Make sure the fabric is following the groove while you push the fabric holder.
7.9 When the fabric holder is reaching the fabric lock on the other side, make sure the fabric holder is following the
groove in the fabric lock.
7.10 Push the fabric holder until it "clicks" in to place in the fabric lock.
WARNING Always make sure the fabric is properly fixed in the frame before using the stroller.
Fabric lock - Right side:
7.11 Place the fabric holder into the fabric lock and push the fabric towards the fabric holder.
7.12 When the fabric is on the fabric holder tip, push it forward in the fabric groove.
7.13 Push the fabric holder until you reach the end of the plastic part. Then place the fabric into the fabric groove and
push the fabric holder to lock it in the frame.
7.14 Push the fabric holder until it "clicks" in to place in the fabric lock. Repeat these steps on the left side.
Assembly of the right side connector
7.15 Assemble the Pram body adapter and the right side connector with the hex key screws and nuts. Repeat on the
left side.
WARNING Always make sure the parts are properly assembled before using the Pram body.
Assemble the Pram body bows
7.16 Push one of the inner bows ends through the hole in the fabric.
7.17 Then use your fingertips to find the hole in the frame. Repeat on both the inner bows.
WARNING Always make sure the bows are properly assembled before using the Pram body.
Go to the chapter: Assembly of the Pram body to finish the assembly of the pram body.
36
NXT 2in1 v1.0
Publicidad
