RIDGID AC9960 Manual Del Operador página 11

MAINTENANCE
BRACKET ADJUSTMENT SCREW
See Figure 13.
The mounting brackets are designed to fit snugly over the
top rails with locking levers in the open position. With the
locking levers in the lowered (locked) position, you should
not be able to slide the mounting bracket assembly along
the top rails or remove the bracket assembly from the top
rails. If the mounting brackets will not fit over top rails, or
if the brackets can be removed from the top rails when the
levers are locked, remove bracket assembly immediately
and adjust bracket adjustment screw. Failure to heed this
warning may result in serious personal injury.
NOTE: The saw should be removed from the mounting
This product has a 90-Day Satisfaction Guarantee Policy,
as well as a Three-year Limited Warranty.
For Warranty and Policy details, please go to
powertools.ridgid.com or call (toll free) 1-866-539-1710.
brackets before attempting to tighten or loosen the bracket
adjustment screws.
To adjust:
 Use a wrench to slightly loosen the nut.
 Turn the screw with a Phillips screwdriver. Rotate clock-
wise if the bracket assembly needs to be tightened or
counterclockwise if the assembly needs to be loosened.
 Install the bracket on the miter stand rails and lower the
locking lever to check the adjustment.
 When the correct adjustment is achieved, wrench tighten
the nut while holding the screw in place to secure.
 Repeat with the second mounting bracket if necessary.
11 - English