Publicidad
Idiomas disponibles
Idiomas disponibles
LOCATE MISSING CYLINDERS
Placing its probe tip next to a sparking wire (DON'T probing it directly), through capacitive coupling, it can
see the high-tension ignition pulses at the same time display a voltage reading. By monitoring each plug
wire in this way you can locate missing cylinders.
MEASURING THE FREQUENCY OF THE HIGH-TENSION IGNITION PULSES
This unit can measure the frequency of the high-tension ignition pulses. Placing its probe tip next to a
sparking wire (DO NOT probing it directly), through capacitive coupling, it can see the high-tension ignition
pulses at the same time display a frequency reading.
MEASURING METHOD
1-cylinder
gasoline engine
As shown in the figure bring the detection head close to the high-tension wire that connect the distributor
and the ignition coil, or to the place where all the high-tension wires of the cylinders are bundled together.
Multi-cylinder gasoline engine without distributor
Bring the detection head close to the place where the high-tension wire of each cylinder is bundled
together.
The measurement is impossible if all the high-tension wires are not bundled together since the distance
between the detection head and each high-tension wire differs.
.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Do not contact probe tip directly to the secondary ignition circuit!
Do not touch the primary or secondary side of the coil by hand.
Risk of electric shock!
Distributor type multi-cylinder
gasoline engine.
Where all the high-tension wires of
cylinders are bundled together.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
WARNING
High-tension wire connecting
distributor and ignition coil.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
