Symbol Function - Suntec Wellness KLIMATRONIC Heat Block PTC Manual Del Usuario

the appliance.
• Do not place the heater directly under a power
socket, near curtains, drapes or other flammable
materials as well as walls and other objects. Keep
a distance of at least 12cm to walls and 2m to
objects.
• Never immerse the appliance, it's cord and plug
into water or other liquids.
• Warning: In order to avoid overheating, do
not cover the heater!
SYMBOL FUNCTION
"OFF" OFF
"FAN" Fan only, no heat
"I" Low heat output
"II" Full heat output
Thermostat:
Turn clockwise to increase the heat output.
Operation:
Plug the heater into a suitable power outlet [observing all the instruction regarding positioning and switch on.
To use the fan only function:
Please turn the control dial to "FAN". The fan will blow out air at room temperature.
•
• If the fan does not operate, the ambient room temperature is cooler than the built-in thermostat "OFF"
level. Please turn the thermostat dial gradually clockwise and the fan will start blowing.
• As soon as the fan starts, the light in the front of the machine will illuminate.
To use the machine for heating:
Please turn the control dial to "I" for low heat and "II" for full heat.
•
• Set the level of heat by turning the thermostat dial gradually clockwise for the lowest heat and fully
clockwise for maximum.
The thermostat will turn the machine off when the selected room heating is achieved, and when the
•
temperature drops it will turn on again automatically.
For maximum heat output use "II" with the thermostat turned fully clockwise.
•
Overheating:
The thermostat will turn the machine off it overheats.
•
Overheating can be caused by obstruction to the air intakes on the back of the machine or the grill on
•
the front. If this occurs please disconnect the machine and allow it to cool for 30 minutes. Remove any
obstruction and turn the machine back on.
If the heater ceases to function, the most likely cause is a blown fuse. Please bring the heater to your
•
market for any services.