Publicidad
Idiomas disponibles
Idiomas disponibles
Product Safety Information
Intended Use:
These Air Percussive Hammers are designed for hammering, punching, cutting, chipping and
scraping material through repetitive application of linear impacts of a tool steel that is retained
and driven by the Hammer.
For additional information, refer to Air Percussive Tool Product Safety Information Manual
Form 04581450.
Manuals can be downloaded from ingersollrand.com
Product Specifications
Type of
Models
Handle
119MAX
119MAXH
135MAX
Pistol Grip
135MAXH
123MAX
123MAXH
† K
= 3dB measurement uncertainty
pA
‡ K
= 3dB measurement uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain con-
densate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a prop-
erly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose coupling
without internal shut-off, to prevent hose whipping if a hose fails or coupling disconnects. See
drawing 16576175 and table on page 2. Maintenance frequency is shown in a circular arrow and
defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
47670292001_ed3
Stroke
Blows
Length
per
Minute
Inch (mm) † Pressure (L
2500
3-1/2 (89)
2600
3 (76)
3500
2-5/8 (67)
WARNING
Sound Level dB(A)
(ISO 15744)
) ‡ Power (L
p
95.7
106.7
98.3
109.3
95
106
* K = Vibration measurement uncertainty
6.
Thread size
7.
Coupling
8.
Safety Air Fuse
9.
Oil
10. Oil - before starting, into air inlet
EN
Vibration (m/s
)
2
(ISO 28927)
)
Level
*K
w
4.5
2.3
5.4
2.9
5.9
4.2
EN-1
Publicidad
