Height Adjustment; Recline Adjustment - Nuna Meet your Bugaboo Owl Manual De Instrucciones

EN
Use Side Impact Protection
1. The enhanced child restraint is delivered with removable side
impact protection pod. This side impact protection pod MUST
be used on the door side of the vehicle. Installation shown in
(13).
2. Press the release button to remove side impact protection pod.
(14)

Height Adjustment

for Head Support and Shoulder Harnesses
Please adjust the head support and check if the shoulder
harnesses are at the correct height according to (15)(16)(17)(18).
When used in rearward facing mode, the shoulder harness
height must be even with or just below the top of child's
shoulders. (15)
When used in forward facing mode, the shoulder harness
height must be even with the top of child's shoulders. (16)
Pull the head support adjustment lever (17), meanwhile pull up or
down the head support until it snaps into one of the 6 positions.
The head support positions are shown as (18).

Recline Adjustment

1. Squeeze the recline adjustment button to adjust the enhanced
child restraint to the proper position. (19)
2. Both rear facing mode and forward facing mode have 5 recline
positions, the recline angles are shown as. (20)
12
Rearward Facing Mode
(Child height 40cm-105cm/ Child weight ≤18kg)
Please install the enhanced child restraint on the rear vehicle
seat, and then place the child in the enhanced child restraint.
1. Push the enhanced child restraint down onto the base (21).
If the enhanced child restraint is secure, the enhanced child
restraint indicator will show green. (22)
2. To release the enhanced child restraint, first take the child out
of the child restraint. Squeeze the child restraint release button
(23)-1, then lift the child restraint up (23)-2.
The enhanced child restraint can ONLY be installed and
released when in rearward facing mode.
3. Press and hold the ISOFIX adjustment button and push the
enhanced child restraint system back until it comes in contact
with the vehicle seatback. (24)
4. Press and hold the rotation button to rotate for easier side
loading/unloading of the child, then rotate the seat to the rear
facing position. (25)
Press the rotation button on either side to rotate the enhanced
child restraint.
5. Press the harness adjustment button while pulling the shoulder
harnesses to the desired length (Pull from below the fixed
shoulder pads to lengthen). (26)
6. Unlock the buckle of the harnesses by pressing the red button.
(27)
7. Place the buckle tongues against the magnetic area on the
outer side of the enhanced child restraint so that the tongues
are held in place. (28)
EN
13