Use; Driving Nails; Unload The Fastening Tool; Usage Of The Battery Charger - FISCHER FGW 90F Manual De Usuario

7

Use

EN
7.1

Driving nails

1. Check the driving depth setting.
2. Bring the nose piece into contact with the working surface.
3. Press the tool against the working surface as far as it will go and until you hear the fan running.
4. Check that the nose piece is positioned correctly on the working surface.
5. Pull the trigger to drive a nail.
6. Lift the tool completely away from the working surface after driving the nail, now the tool is ready
again to drive another nail.
7. Check the position of the nail, if it is driven not deep enough or too deep into the surface adjust
the driving depth with the depth adjustment wheel accordingly for best setting results.
8. Always remove the fuel cell and the battery when the work with the tool is finished
or before leaving the tool unattended.

7.2 Unload the fastening tool

7.2.1.

Remove the battery

Press the red release button on the bottom of the battery and pull the battery out of the tool.

7.2.2. Remove the fuel cell

Open the fuel cell compartment (see chapter 4.8) and remove the fuel cell.
Close the compartment cover again.

7.2.3. Unload the magazine

Push the red button on the nail push button and bring it back to initial position in a controlled
manner. Now push the safety clip in the magazine downwards and remove the nail strip.

7.3 Usage of the battery charger

To recharge the battery, plug in the battery charger BC 7.2V. When the battery charger is properly
plugged in, the green LED will light up and the charger is ready to use. To charge the battery, insert
the battery into the battery charger in the right way. When the battery is charging properly, the red
LED will light up. When you plug in a battery and the green LED is lighting up, the battery is already
fully charged, and no further charging is needed.
Once the battery is fully charged the green LED will light up instead of the red one. A fully charge of
an empty battery takes around 1.5 hours. If the red and green LED will flash in alternate sequence,
there is an issue or failure with the battery and the battery must not be used anymore.
36