FLAEM AIRMIST Manual De Instrucciones página 5

The cap (C1.4) provided with the nebuliser RF6 Basic
medication in 2 modes:
"standard mode"
for optimum delivery
and minimum waste
of medication
6. Start the unit by means of switch (A1) and breathe in and out deeply.
7. When the treatment is finished, turn off and unplug the unit.
WARNING: If after the therapy session moisture accumulates in the tube (B), remove the
tube from the nebulizer and dry it using the compressor air flow; this operation will
prevent mold from forming inside the tube.
Using the manual nebulisation control
To achieve continuous nebulisation action you should not use the manual nebulisation
control (C6), especially in the case of children or persons with reduced physical, sensory, or
mental capabilities. The manual nebulisation control is useful for limiting dispersion of the
medication in the surrounding environment.
To start nebulizing close with
a finger the hole of the nebu-
lizer manual control (C6) and
breathe in gently; we recom-
mend to hold your breath for
a moment so that the inhaled
aerosol droplets can be de-
posited,
CLEANING, SANITIZATION, DISINFECTION AND STERILIZATION
Turn off the unit before any cleaning and disconnect the power cord from the mains.
UNIT AND OUTER SURFACE OF THE TUBE
CLEANING
Only use a cloth dampened with antibacterial detergent (non-abrasive and free of solvents
of any kind).
NEBULIZER AND ACCESSORIES
We recommend a personal use of both the nebulizer and accessories to avoid any risk of
infection or contagion. Open the nebulizer by turning the top (C1.3) counterclockwise,
then remove the nozzle from the top (C1.3), and disassemble it as shown in the "Connection
Diagram" section C1.
SANITIZATION
Before and after each use, sanitize the nebulizer and accessories according to one of the
methods described below.
(Method A): The accessories that can be sanitized with the method A are (C1.1-C1.2-
C1.3-C1.4-C2-C3-C4-C5-C6)
Sanitize the accessories in warm (approximately 40° C) drinking water with mild
dishwashing liquid (non abrasive) or in the dishwasher with hot cycle
(Method B): The accessories that can be sanitized with the method B are (C1.1-C1.2-
C1.3-C1.4-C2-C3-C4-C5-C6)
Sanitize the accessories by immersion in a solution consisting of 50% water and 50% white
makes it possible to deliver the
2
meanwhile, to disable nebu-
lizing, remove your finger
from the hole of the nebulizer
manual control to avoid the
waste of drug, optimizing
its acquisition. Then exhale
slowly.
5
"high speed mode"
for a quicker treatment