Basic Parameters - Roborock Q7+ Manual Del Usuario

C8-1—Remove the dustbin cover vertically
as shown.
C8-2—Lift the dust bag out of the dustbin
and discard it.
Note: The dust bag handle seals the bag on removal to prevent
dust leakage.
C8-3—Clean the filter with a dry cloth.
C8-4—Install a new dust bag in place along
the slot and put the dustbin cover
back.
Air Duct
C9
* Replace as needed.
C9-1—Unscrew the screws (10) and remove
the cover.
C9-2—Wipe the air duct and cover with a
dry cloth.
C9-3—Re-install the cover and screw it
back in place.
Robot Sensors
C10
* Clean every month.
Use a soft, dry cloth to wipe all sensors,
including:
C10-1— Dock Locator
C10-2—Wall Sensor
C10-3—Four Cliff Sensors
Charging Contact Areas
C11
* Clean every month.
Clean the charging contacts of the dock and
the robot with a soft, dry cloth.
Battery
The robot is equipped with a high-
performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged during
normal use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.

Basic Parameters

Robot
Model Q400RR
14.4V/5200mAh
Battery
lithium-ion battery
Weight Approx. 3.2kg
Rated Input 20V
Charging Time < 6 hours
Note: The serial number is on a sticker on the underside of
the robot.
Auto-Empty Dock
Model AED03HRR, AED04HRR
Rated Input Voltage 220-240V~
Rated Frequency 50-60Hz
Rated Input (Dust Collection) 5A
Rated Input (Charge) 0.5A
Rated Output 20V
14.4V/5200mAh
Charging Battery
lithium-ion battery
10
Errors
If an error occurs while the robot is cleaning, the
power indicator will flash red quickly, and a voice
alert will sound. Refer to the following table for
troubleshooting.
1. After resolving any of the following errors, relocate
your robot and restart cleaning.
2. After any sensor errors, clean the sensor and retry.
3. If the battery is at an abnormal temperature, wait
for it to return to normal before use.
LiDAR turret or laser blocked. Check
Error 1:
for obstruction and retry.
Bumper stuck. Clean it and lightly tap
Error 2:
to release it.
Wheels suspended. Move robot and
Error 3:
restart.
Cliff sensor error. Clean cliff sensors,
Error 4:
move robot away from drops and restart.
Main brush jammed. Clean main brush
Error 5:
1.2A
and bearings.
Side brush jammed. Remove and clean
Error 6:
side brush.
Wheels jammed. Move the robot and
Error 7:
restart.
Robot trapped. Clear obstacles
Error 8:
surrounding robot.
Error 9: No dustbin. Install dustbin and filter.
Error 12: Low battery. Recharge and retry.
Charging error. Clean charging
Error 13:
contacts and retry.
Error 14: Battery error.
1.2A