Publicidad
Idiomas disponibles
Idiomas disponibles
Setup
Select under desk heater
1. Find the two feet supplied in the
package.
2. Fit to the long lower side of the heater.
The SMART-R power box at the back of
the panel should be at the bottom edge
of the heater.
3. Use a screw driver to tighten the friction
screws against the rear surface of the
heater. (Note: tightening the screws
against the front will damage the front
surface of the heater).
The Select under desk heater comes with a
factory fitted plug and can be plugged into
an available socket under the desk.
The SMART-R receiver allows your under
desk heater to operate in two different ways
according to preference:
• It can act in a simple "on / off" mode
using the foot control;
• It can connect to wifi and be managed via
the SmartLife App.
Controls on the SMART-R receiver are as
follows:
1. LED
display
showing
temperature
2. Wifi indicator
3. Timer On/Off indicator
4. On / Off button
5. Manual pairing button
6. Manual Temperature Increase
7. Manual Temperature Decrease
8. Built-in
Thermostat.
downwards to sense the temperature
around the heater.
9. Power Switch (I = On, O = Off)
10. Mains cable
11. Foot Switch.
ENGLISH
setpoint
Pull
gently
Publicidad
