Safety; Introduction; Installation; Connecting Can Bus Cables - Vetus DBPPJA Manual De Instalación

1

Safety

Warning indications
The following warning indications are used in this manual in the con-
text of safety:
Indicates that great potential danger exists that can lead to serious
injury or death.
Indicates that a potential danger that can lead to injury exists.
Indicates that the usage procedures, actions etc. concerned can re-
sult in serious damage to or destruction of the engine. Some CAU-
TION indications also advise that a potential danger exists that can
lead to serious injury or death.
Emphasises important procedures, circumstances etc.
Symbols
Indicates that the relevant procedure must be carried out.
Indicates that a particular action is forbidden.
Share these safety instructions with all users.
General rules and laws concerning safety and accident prevention
must always be observed.
Installation manual DBPPJA - Proportional panel for bow and stern thruster
D
anGer
W
arninG
c
aution
n
ote
2

Introduction

This manual gives guidelines for installing the VETUS DBPPJA control
panel.
For operation, refer to the user manual.
The quality of installation will determine how reliably the bow and/or
stern thruster performs. Almost all faults can be traced back to errors
or inaccuracies during installation. It is therefore imperative that the
steps given in the installation instructions are followed in full during
the installation process and checked afterward.
Alterations made to the bow thruster by the user will void any li-
ability on the part of the manufacturer for any damages that may
result .
• During use ensure the correct battery voltage is available.
Changing over the plus (+) and minus (-) connections will
cause irreparable damage to the installation .
Never work on the electrical system while it is energized .
3

Installation

• Mount the control panel at the helm position. There must be 150
mm of free space behind the panel.
• Make a hole of the correct size and fit the panel. See principal di-
mensions page 61
3 .1

Connecting CAN bus cables

See chapter 6, page 62 for the connection diagrams.
The CAN bus power supply must always be
n
ote
connected to 12 Volt
Consult the relevant Bow and/or Stern Thruster installation manual
for the detailed CAN-BUS diagrams.
ENGLISH
W
arninG
W
arninG
020813.11
11