G-Systems GSE Light timer Manual Del Usuario página 23

Push ENTER and the current language starts to blink. Change the
language with UP/DOWN arrows and SAVE/EXIT to save and return to the
sub menu.
Push ENTER the current setting starts to blink. Chose with UP/DOWN
arrows.
ON = The back-light is constantly on (not recommended)
Auto = The back-light switch OFF after 1min. Stand-by and starts again as
soon you push any button.
OFF = The back-light is constantly OFF
Push SAVE/EXIT to save and return to the sub menu.
Here you can chose your output signal to the lamp. 0-10V or PWM
(pulse width modulation)
Push ENTER and change the value with UP/DOWN arrows. Push
SAVE/EXIT to save and return to the sub menu.
Here you can calibrate your temperature sensors A+B. Push ENTER
and choose which temperature sensor you like to adjust. Choose with the
UP/DOWN arrows and ENTER to confirm, the value starts to blink. Adjust
the temperature with the UP/DOWN buttons in 0.1°C steps. Push
SAVE/EXIT to save and return to the sub menu.
Push ENTER and choose with the UP/DOWN arrows NO or YES. Push
SAVE/EXIT to confirm.
The light controller will load all the factory default settings and start
again.
Push ENTER to see the current software version.
Push SAVE/EXIT twice to return to the main screen.
GSE Light timer
Set languages
Set back-light
Set output signal
Set temperature offset
Reset factory settings
Software version
EN
27 21