Publicidad
Idiomas disponibles
Idiomas disponibles
-
press without releasing keys CH1 and PROG till LEDs DL1 and DL2 start flashing quickly with a
yellow light. At this point release the keys and press them again till the LEDs go off confirming the
operation is complete (if they are not pressed the board reverts to normal operation after about
12 seconds).
HARD RESET (factory setting):
-
Keep the CH2 and PROG keys pressed until the green DL1 and the red DL2 LEDs start flashing quickly.
At this point, release the keys and press them again until the DL1, DL2 and DL8 LEDs switch off.
Release the keys; all the LEDs will turn off confirming that the operation is complete. After about
5 seconds the DL2 will start flashing red/green.
If they are not pressed and you wait, the control unit returns to normal operation after 12 seconds.
Upon restarting, it will be necessary to carry out the memorization procedure.
In case of Hard Reset the memory of the radio receiver will not be erased: all existing
transmitters remain programmed.
11. SET-UP FOR OPERATION WITH TAU APPS
In order to use the TauApp and TauOpen apps, it will be necessary to connect to input J4 of the control
unit using the supplied cable, the respective T-WIFI and T-CONNECT devices. To activate the operation
of the apps see the respective instructions.
12. MALFUNCTIONS: POSSIBLE CAUSES AND SOLUTION
The automation does not start
a- Check there is 230V AC power supply with the multimeter.
b- Check, in the standard mode, that the NC contacts on the board are really normally closed (4
green LEDs on).
c- Set dip-switch 6 (phototest) OFF.
d- Increase the FR trimmer to the limit.
e- Check that the fuses are intact with the multimeter.
The radio control has very little range
a- Check that the ground and the aerial signal connections have not been inverted.
b- Do not make joints to increase the length of the aerial wire.
c- Do not install the aerial in a low position or behind walls or pillars.
d- Check the state of the radio control batteries.
The gate opens the wrong way
Invert the motor connections on the terminal block, terminals 28 - 29 and terminals 23 - 24 (if
used).
13. GUARANTEE: GENERAL CONDITIONS
TAU guarantees this product for a period of 24 months from the date of purchase (as proved by the
sales document, receipt or invoice).
This guarantee covers the repair or replacement at TAU's expense (ex-works TAU: packing and trans-
port at the customer's expense) of parts that TAU recognises as being faulty as regards workmanship
or materials.
For visits to the customer's facilities, also during the guarantee period, a "Call-out fee" will be charged
for travelling expenses and labour costs.
The guarantee does not cover the following cases:
•
If the fault was caused by an installation that was not performed according to the instructions
provided by the company inside the product pack.
•
If original TAU spare parts were not used to install the product.
•
If the damage was caused by an Act of God, tampering, overvoltage, incorrect power supply,
29
Publicidad
