Publicidad
Step 5
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten a EXTENSION RAIL (40MA) to the LEFT END (B). Use two GOLD 5/16" FLAT HEAD SCREWS (3S)
through holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the LEFT END. Turn a SCREW into
this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Insert a WOOD DOWEL (15F) into the LEFT END (B).
40MC
Push the black lever in and pull the SLIDE from the RAIL.
3S
GOLD 5/16" FLAT HEAD SCREW
(2 used for the RAILS)
E
Open end
www.sauder.com/service
D
3
2
1
B
426133
40MA
4
15F
Page 11
Publicidad
