Publicidad
Step 1
å
Assemble your unit on a carpeted floor or on the empty carton to avoid scratching your unit or the floor.
å
Turn six BLACK 9/16" FLAT HEAD SCREWS (32S) into the LEFT END (B) until the shoulders of the SCREWS rest on the
surface of the LEFT END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the UPPER END MOLDING (K) onto the LEFT END (B). Line up the groove in the MOLDING over the heads of the
SCREWS in the LEFT END.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
Slide the END MOLDING (M) onto the LEFT END (B) until it is against the UPPER END MOLDING (K). Line up the groove in
the MOLDING over the heads of the SCREWS in the LEFT END.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
BLACK 9/16" FLAT HEAD SCREW
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 6
Shoulder
32S
(6 used in this step)
Look for this icon. It means a
video assembly tip is available at
www.sauder.com/service/tips
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
B
426133
These edges
should be even.
K
M
www.sauder.com/service
Publicidad
