Publicidad
Step 10
å
Turn six BLACK 9/16" FLAT HEAD SCREWS (32S) into the RIGHT END (A) until the shoulders of the SCREWS rest on the
surface of the RIGHT END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the UPPER END MOLDING (K) onto the RIGHT END (A). Line up the grooves in the MOLDINGS over the heads of the
SCREWS in the RIGHT END .
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
Slide the END MOLDING (M) onto the RIGHT END (A) until it is against the UPPER END MOLDING (K). Line up the
grooves in the MOLDINGS over the heads of the SCREWS in the RIGHT END.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
Shoulder
BLACK 9/16" FLAT HEAD SCREW
(6 used in this step)
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 16
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
32S
K
A
426133
These edges
should be even.
M
www.sauder.com/service
Publicidad
