Publicidad
Step 2
Step
å
Slide the LOWER END MOLDING (L) onto the LEFT END (B).
Line up the groove in the MOLDING over the heads of the
SCREWS in the LEFT END.
å
NOTE: The MOLDING should be even on both edges of the END.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it
and slide it on again.
www.sauder.com/service
B
Shoulder
426133
Just think. The sooner
you do this, the sooner
you do something else.
L
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 7
Publicidad
