To Engage And Disengage The Parking Brake; To Stop The Product - Husqvarna TS 354XD Manual De Usuario

To move forward and rearward
Note:
The forward and reverse drive pedals go
back to neutral position when not pushed down.
The direction and speed of movement is controlled
by the forward and reverse drive pedals.
A
1. Start the engine and slowly release the parking
brake (A).
2. To start movement, slowly push the forward drive
pedal (B) or the reverse drive pedal (C) down.
3. Push the forward drive pedal (B) or the reverse
drive pedal (C) down more to increase speed.
To use the cruise control
Only use the cruise control for forward travel on
smooth, straight surfaces. The cruise control will
disengage automatically if the conditions for cruise
control become unsatisfactory.
1. Push the forward drive pedal (B) down. Keep the
forward drive pedal in a position that gives the
correct speed for the terrain.
A
2. Pull the cruise control lever (A) up and hold it
while you release the forward drive pedal.
3. Release the cruise control lever to engage the
cruise control.
4. Push the brake pedal or tap on the forward drive
pedal to disengage the cruise control.
1940 - 006 - 13.09.2022
B
C
B
To engage and disengage the
parking brake
1. To engage the parking brake, push down the
brake pedal (A) fully to the lowest position.
A
2. With the brake pedal pushed down, pull up the
parking brake lever (B).
3. Release the brake pedal.
4. Release the parking brake lever.
Note:
Make sure that the parking brake holds
the product safely.
5. To release the parking brake, push down the
brake pedal.

To stop the product

WARNING:
product, engage the parking brake and
remove the ignition key before you go
away from the product.
CAUTION:
the warm engine can cause burn
damage to the grass. To prevent burn
damage , to the grass, always stop the
engine when you stop the product on
grass areas.
1. Push down on the brake pedal (A) fully until the
product stops fully.
2. Disengage the cutting deck. Refer to
and disengage the cutting deck on page 16 .
3. Put the throttle control in the slow position and
let the engine operate at idle speed for some
minutes.
B
Always stop the
The exhaust gas from
A
To engage
15