Publicidad
Idiomas disponibles
Idiomas disponibles
Transportation
Note:
Close and attach the hood to the product
during transportation to prevent damage. Connect
the hood to the product with the correct tools (rope,
cord and so on).
When you move the product, put the freewheel
control in freewheeling position to disengage the
transmission. Freewheel control is at the rear
drawbar of the product.
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If
you keep fuel in the fuel tank for 30 days or more,
tacky particles can cause blockage in the carburetor.
This has a negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is
not necessary. If you use standard gasoline, do
not change to alkylate gasoline. This can cause
sensitive rubber parts to become hard. Add stabilizer
to the fuel in the tank or in the container used for
storage. Always use the mixing ratios given by the
manufacturer. Run the engine for a minimum of 10
minutes after you add the stabilizer until it flows into
the carburetor.
WARNING:
product with fuel in the tank in an indoor
location or in locations with bad airflow.
Risk of fire if fuel fumes come near
open flames, sparks, or pilot lights in
for example boilers, hot water tanks and
clothes dryers.
WARNING:
and other flammable materials from the
product to decrease the risk of fire. Let
the product become cool before you put
it in storage.
1940 - 006 - 13.09.2022
Transportation, storage and disposal
Do not keep the
Remove grass, leaves
1. Lift the attachment to the highest position with
the attachment lift control.
2. Pull the freewheel control out and into the slot
and release to hold it in the disengaged position.
3. Do not move the product at more than two (2)
mph (3.2 km/h).
4. To reengage transmission, reverse the above
procedure.
Tow safety
•
Only use tow equipment approved by
Husqvarna.
•
Use the tow bar to attach the equipment.
•
Do not tow equipment that is heavier than the
maximum permitted weight.
•
Make sure that no other persons is near the
product when you tow equipment.
•
Do not tow equipment on slopes or rough
ground.
•
Operate the product at low speed when you tow
equipment.
Storage
CAUTION:
battery from the product, do not keep
the battery directly on concrete or damp
surfaces.
•
Clean the product, refer to
on page 21 .
•
Repair paint damages to prevent corrosion.
•
Examine the product for worn or damaged parts
and tighten loose screws and nuts.
•
Examine the belts and replace them if they are
worn or damaged.
•
If the product is put in storage for the winter,
remove and clean the cutting deck. Keep the
cutting deck in a clean and dry environment.
•
Charge the battery fully.
Note:
It can be necessary to charge the
battery again after a period of time in storage.
•
Disconnect the battery and clean the terminals
and connectors. Refer to
and the terminals on page 24 .
If you remove the
To clean the product
To clean the battery
CAUTION:
Risk of short circuit.
Make sure that you put the
disconnected battery cables in a
position where they cannot touch the
battery or the terminals.
37
Publicidad
Solución de problemas
