Mounting - Kicker KMXL65 Manual Del Propietário

Mounting

The sound produced by the KMXL coaxials is
directional. Find the best location for stereophonic
sound. If necessary, add more KMXL coaxial
speakers to the system to help distribute and balance
the sound-stage.
After determining the best mounting locations,
carefully check the areas where the mounting
hardware will be placed. If a mounting location does
not already exist, cut a hole in the desired location
using the templates from the KMXL product page
at KICKER.com. If necessary, pre-drill the mounting
screw holes using a 7/64" (2.5mm) bit following the
template. For KMXL65 and KMXL8 only: Note the
screw holes that will be used to secure the grille
in the desired orientation. Install four screws in the
other holes not to be used for the grille to secure the
speaker to the surface.
Use masking tape to help prevent damage to the
paint in the locations to be cut or drilled. If you are
mounting the speaker to a surface made from thin,
soft material such as aluminum, use the provided
stainless steel speed nuts to provide threads for the
stainless steel mounting screws. If the speaker cut-
out locations require you to cut metal, avoid structural
metal and braces. If the panel cannot support the
weight of the speaker, an optional reinforcing ring may
be fastened or adhered to it.
Make sure the mounting screws and speed nuts will
not puncture the fuel cell, wiring, or interfere with any
mechanical parts on the underside of the mounting
surface. If the supplied hardware is not applicable
to your installation, some other means of securely
attaching the speakers to the boat must be used,
such as the KMTC Towers.
English 7