Cameo S4 IP Manual De Usuario página 15

8
LC DISPLAY
The LC display shows the currently activated mode (main display), the menu items in the menu
and the numerical value or operational status in certain menu items. If there is no input for
approx. one minute, the display automatically returns to the main display. Note regarding the
main display in operating modes with external control: As soon as the control signal is interrupted,
the characters in the display begin to flash. When there is a control signal again, the flashing
stops.
9
DIM / SELECT / ENTER
Rotary-push encoder for the adjustment and control of the spotlight.
DIM – In the stand-alone modes CCT, HSI, Direct LED, Colour Coordinates, Gel, User Colour, Play
Loop and Light Simulation, the encoder has the function of the master dimmer (rotate encoder).
SELECT – Turn the encoder to SELECT the menu items on the menu level and change a value in a
menu item (e.g. DMX start address).
ENTER - 1. Press ENTER to access the menu level to select the mode. 2. You move down one
level in the menu structure. 3. You can confirm a value or status change by pressing ENTER, such
as changing the DMX start address.
10
The function of the middle push-button rotary encoder (turn and press) is shown in the
corresponding menu item in the centre of the display (centre line = turn, bottom line = press).
11
ESC
If the press function of the right push button rotary encoder is not explicitly shown at the bottom
right of the display, pressing the encoder has the function of moving up one level in the menu
structure.
12
BLACKOUT
Shortcut button with blackout function. Press the button to activate blackout. Press the button
again to deactivate blackout.
13
CCT
Shortcut button for directly calling up the stand-alone mode CCT.
14
USER 1
With a stand-alone mode, freely assignable button 1 (see menu item Settings -> User Buttons).
15
USER 2
With a stand-alone mode, freely assignable button 2 (see menu item Settings -> User Buttons).
15