Cameo S4 IP Manual De Usuario página 25

Now give the colour sequence an individual name, up to 12 characters long, by turning the left
encoder to select a letter, underscore or number for the first character of the name and confirm
by pressing the left encoder. This is followed by the input for the second digit and so on. When the
name is complete, press the middle encoder (Save&Next) to go to the next processing step. If you
press "Save&Next" before selecting a letter, underscore or number for the first digit, the previous
name will be retained and you will immediately be taken to the next processing step.
Select a step in the 8-step sequence (Step 1 – Step 8) by turning the left encoder to set the colour
of the step. Now select one of the colours in the standalone mode User Colour or Blackout or
Skip Step by turning the middle encoder. Proceed in the same way to define the colours of the
other steps. Complete the process and save the sequence by pressing the left encoder (ENTER).
STANDALONE MODE 'LIGHT SIMULATION'
Starting from the main display, press the left push button rotary encoder to access the menu for
selecting the mode. Turn the left encoder (SELECT) to choose Light Simulation (see left arrow)
and confirm by pressing the left encoder (ENTER). Now select one of the 8 pre-programmed
simulations again by turning the left encoder. Confirm your selection by pressing the left encoder
(ENTER). Use the left encoder to adjust the brightness (DIM), step duration (0.1 seconds to 21
minutes and 2 random modes) and fade time (0 seconds to 18 minutes and 2 random modes)
using the middle and right encoders as shown.
Rotate encoder =
Set brightness (DIM)
Press encoder =
Mode selection
Rotate encoder =
Set fade time (t-Fade)
Press encoder =
Open the main menu (Menu)
Rotate encoder =
Set step duration (t-Step)
Press encoder =
back to colour sequence selection (Back)
25