Publicidad
Idiomas disponibles
Idiomas disponibles
L
Fig. 13
O
O
L
Fig. 14
STEP 7:
Place Small Canopy (L) over the top ribs of Two-Tier Ribs (D), and
Extenders (O). Place the pockets found under the corners of the Small
Canopy (L) over the Extenders (O), and extend the Extender (O) out to
the first eyelet to make the canopy taut, see Fig. 13.
Open Main Canopy (M), and spread the fabric over ribs. Pull the
corners of Main Canopy (M) over each corner of the frame. Please note
that getting the fourth, and final corner of the canopy over the
frame may be difficult since the canopy is intended to taut when
assembly is completed.
Insert two Stakes (2) through eyelets found at the bottoms of each
Corner Panels (A), see Fig. 14. Use a hammer (not included) to gently
tap Stakes (2) in place, securing the frame to the ground.
14
Assembly Instructions
L
M
2
3
3
N
N
STEP 8:
Please note that the Insulated Panels (N) will be installed outside of the
gazebo frame before getting started.
Insert Panel Loops (4) through grommets closes to zippers of Insulated
Panels (N), followed by three Panel Rings (3). The loops of the Panel
Loops (4) should be outside the gazebo frame, see Fig. 15. Continue
using Panel Rings (3) through remaining grommets found along the top
of Insulated Panels (N). Hang the Insulated Panels (N) from the top
bar of Half-Arches (B&C) using Panel Rings (3), and Panel Loops (4),
see Fig. 16.
Assembly Instructions
Fig. 15
3
Fig. 16
4
15
Publicidad
