Dimensions (Mm) - OHAUS Defender 3000 Serie Manual De Instrucciones

EN-6
Defender 3000 SERIES FLOOR SCALE, INSTALLATION OF OPTIONAL FOOT PLATES AND
RAMPS
Plates are required for certifiable installations. Installation of each Ramp also requires the installation of one set of Foot Plates.
Foot Plates are available separately and are included with the Ramp accessory kit. Refer to Figure 3 for mounting of the Foot
Plates and Ramps. Installation of Floor Plates and Ramps must be done before final placement of the Floor Scale.
LEGEND: 1.Foot Plate, 2. Bolt, 3. Spring Washer, 4. Washer, 5. Expanding Bolt, 6. washer, 7. Nut
Notes:
1. Expanding bolts require 12.5mm diameter holes drilled 60mm deep into the floor surface.
2. Foot Plate center to center dimensions W and L are shown in Table 4.
3. The Floor Scale must be positioned so that the load cell feet rest within the large holes of the Foot Plates.
4. Ensure that a free air gap exists between the sides of the Floor Scale and the edges of the Ramps.
MODELS
Ramp for
i-DF600B1R/C1R,
i-DF1500B1R/C1R
Ramp for
i-DF1500B1L/C1L,
i-DF3000B1L/C1L,
Ramp for
i-DF1500B1X/C1X,
i-DF3000B1X/C1X
Ramp for
i-DF1500B1RL/C1RL,
i-DF3000B1RL/C1RL
Ramp for
i-DF1500B1LX/C1LX,
i-DF3000B1LX/C1LX
Figure 3. Optional Foot Plate and Ramp Installation
TABLE 6. DIMENSIONS FOR FLOOR PLATE AND RAMP INSTALLATION
RAMP
A
1000
1250
1500
1250
1500

DIMENSIONS (mm)

B W
670 890
670 1140
670 1390
670 890
670 1140
Defender 3000 Series Floor Scale
FOOT PLATE CENTERS
L
890
1140
1390
1140
1390