Air Filter; To Clean The Air Filter; To Apply Oil To The Foam Air Filter - Husqvarna 135R Manual De Usuario

1. Clean the cooling system with a brush weekly or
more frequently if it is necessary.
B
2. Make sure that the cooling system is not dirty or
blocked.
To lubricate the bevel gear
1. Remove the cutting equipment.
2. Put the product with the grease plug at its highest
position.
3. Remove the grease plug.
4. Look into the grease plug hole and turn the drive
shaft. The grease level (A) must be in level with the
top of the gear cogs (B).
A
5. If the grease level is too low fill the bevel gear with
Husqvarna bevel gear grease. Fill slowly and turn
the drive shaft as you apply the bevel gear grease,
stop at the correct level (B).
CAUTION:
grease can cause damage to the bevel
gear.
22
C
A
B
An incorrect quantity of
6. Install the grease plug.

Air filter

Remove dust and dirt from the air filter to keep it clean
and prevent these problems:
• Carburetor malfunctions.
• Problems when you start the product.
• Loss of engine power.
• Increased wear to engine parts.
• Too much fuel consumption.

To clean the air filter

Clean the air filter regularly from dirt and dust. This
prevents carburetor malfunctions, starting problems,
loss of engine power, wear to engine parts and more
fuel consumption than usual.
• Clean the air filter at an interval of 25 hours, or more
regularly if you operate the product in conditions with
much dust.

To apply oil to the foam air filter

CAUTION:
special air filter oil. Do not use other types
of oil.
WARNING:
The air filter oil can cause skin irritation.
1. Put the foam air filter in a plastic bag.
2. Put the oil in the plastic bag.
3. Rub the plastic bag to supply the oil equally across
the foam air filter.
Always use Husqvarna
Put on protective gloves.
975 - 005 - 14.11.2022