A minimum of three healthy adults are required to move and install the awning as the product is big
and heavy. Do not try to install the awning alone. If the awning falls, it could cause serious injuries
and damages! Contact an authorized assembler for help.
Do not install the awning when you find damage parts are that parts are missing.
Do not allow children to play in the working area during assembly
This product is only suitable for installation in the cement wall or ceiling.
Nobody is allowed to change the products' design and structure without the permission of
manufacture or authorized deputy.
Please make sure that your hands are clean at the time of the assembly; otherwise you may soil the
awning fabric and frame.
The operation in frosty conditions may damage the awning.
The operation in snowy conditions may damage the awning.
In case of rain Retract the awning if pitch angle is less than 14°.
Nobody is allowed to climb onto the awning; hanging anything on the awning is
Sheeting was used to protect the paint. This must be removed afterwards.
When extended, various forces, including wind and rain, will affect an awning. These sometimes
substantial forces must be absorbed by the awning and transferred to the assembled structure via its
mounting brackets. Under extreme loads, excessive attractive force can be exerted on the anchor
bolts. Therefore, before starting assembly, check the load-bearing capacity of the mounting base
and if necessary take corresponding measures to ensure stable installation of the brackets. If the
mounting base is unstable, you may wish to consult a specialist in your vicinity.
The awnings are intended as a protection against the sun only. It is not to be used during periods of
strong wind, rain, hail, or snow. In case of such conditions, retract the awning immediately.
Preparation
Carefully remove the awning from the box and remove the styrofoam protectors from the awning. Remove
the plastic bags and plastic guards from the awning and carefully place the awning aside to avoid having it
damaged by scratches or otherwise damaged or soiled during assembly. Check the number of parts in the
packaging whether the packing list requirements, the quality of parts availability issues, if questions, please
contact the supplier.
Be aware the sudden extension may occur during unpacking.
Tools needed for assembly:
Drill
Masonry drill bit, 14 mm Level indicator
Wrench 14mm、17mm and 19mm
Stepladder
Tape measure
Chalk or marker pen
Wooden hammer
16