Publicidad
Idiomas disponibles
Idiomas disponibles
In case the square tube cannot be inserted into the wall brackets, you should slightly loosen the wall
bracket screws and then try it once again. This time, move the awning slightly forward and
backwards until the bearing tube slips into the brackets. Then immediately insert the safety screw
and fix it with lock not. Use a 19 mm wrench to tighten it.
Attention! Also tighten the safety screws of wall brackets again and ensure that they have been
adequately secured.
After the awning has been mounted properly and has been adequately secured please take away
the protective band that you can find on the arm of the awning. Otherwise it cannot be opened. Store
the protective band; you can use it in future when storing the awning.
Attention: Misplacing and misapplying the awning can cause seriously danger. Only mount the
awning yourself when you understand the mounting instructions completely and when you are sure
that the wall or ceiling you want to mount the awning on is suitable. For your own and the safety of
other people please contact an authorized assembler for help.
Operation
Adjusting the pitch angle
The awning is already delivered with an optimally adjusted pitch angle. However, users can adjust the screen
angle within a range of 5 - 50 degrees as desired.
Extend the awning no more than 1/4 of its full projection before adjusting.
Once you have achieved the highest possible range of pitch, the loop cannot be turned any
farther. Do not force it! Failure to follow these instructions can damage the flex pitch
shoulder and void the warranty.
Drawing 7:
The pitch angle can be adjusted on all arms
in the adjusting area (7.1).
Take off the plastic caps, loosen the locking
bolts 9 with a 14mm wrench.
Turn the adjusting screw clockwise to
decrease the pitch angle; turn
counter-clockwise to increase the pitch
angle. When achieved to the desired pitch
angle, tighten the safety nuts and put the
plastic caps back on it (7.2).
Follow the same procedure until all arms have been adjusted to the desired level.
The front bar must always be level. To ensure that both sides are completely level, a built-in level
is located on the front bar: the air bubble must be exactly in the middle of the level.
7
adjusting
area
7.1
20
Publicidad
