Description Of Controls - Vollrath STOELTING SCBA118-37 Manual Del Propietário

5 If using freeze-dried bases to be diluted with milk or water,
prepare the product in a separate container and only pour it into
the machine bowls after making sure that it is homogeneous
and that the powder is well dissolved.
IMPORTANT
NOTICE: Amount of Sugar - The sugar level of the mix or
recipe must be between 10-17 percent. Mixes with sugar
levels outside of this range will not freeze properly. Less
than 10 percent, the machine may over-freeze the mix.
Greater than 17 percent, the machine will have difficulty
freezing the mix.
NOTICE: Custom Recipes - When using a custom recipe
instead of a commercial mix, Stoelting strongly recom-
mends using a refractometer to measure the sugar con-
tent.
NOTICE: Using Alcohol - Alcohol is an anti-freeze.
Replace NO more than ¼ of the water required in the
recipe with alcohol.
IMPORTANT
Use the dispenser with food products only.
6 The dispenser must operate without interruption: The
cooling system for each bowl will automatically stop when the
product is ready to be dispensed, maintaining the set density.
The augers will still continue to operate.

6. 1 DESCRIPTION OF CONTROLS

The dispenser is equipped with a main switch together with a
touchpad and a screen for each bowl. These devices allow set-
ting the dispenser operation mode. The following modes are
available:
STANDBY: The dispenser is filled and it is ready to start.
GRANITA MAKING: The dispenser makes granitas according
to the product in the bowl.
PRODUCT PRESERVATION: The dispenser keeps the liquid
product at a suitable temperature for its preservation. This mode
can be selected during the night, since it allows maintaining the
product quality while reducing energy consumption.
WASHING: Only the mixers work, the cooling system is
stopped. This mode can be selected during the dispenser
washing.
MAIN SWITCH: The main switch is located under the dispenser,
on the left side. It has the following functions:
Position 0: The dispenser is off.
Position I: The dispenser can work but it is in Standby mode.
Only pilot light (A) is on.
The keys have the following functions:
Pilot Light (A):
On the right bowl: If the pilot light is on, it indicates that the
machine is in Standby mode; If the pilot light is off, it indicates
that the machine is working; If the pilot light flashes, it indicates
that the right bowl only is off.
On the left bowl: If the pilot light is off, it indicates that the bowl
is working; If it flashes it indicates that the bowl is off.
Standby Key (B):
On the right bowl: If it is pressed for two seconds, it allows
turning on and off the whole machine; If it is pressed quickly
while the machine is working, it allows turning on and off a single
bowl (on machines with multiple bowls only). If it is pressed twice
quickly: It allows turning on and off the cover lights.
On the left bowl: If it is pressed quickly while the machine is
working, it allows turning on and off a single bowl.
Product Preservation Key (C):
If it is pressed quickly, it allows increasing density. If it is pressed
for one second while the machine is running in the Granita
making mode, it allows switching to the Product Preservation
mode. If it is pressed for one second while the machine is
running in the Product Preservation mode, it allows switching to
the Washing mode.
Granita Making Key (D):
If it is pressed quickly, it allows decreasing density. If it is
pressed one second while the machine is running in the Product
Preservation mode, it allows switching to the Granita Making
mode.
If it is pressed one second while the machine is running in the
Granita Making mode, it allows resetting possible alarms.
The display shows the following icons:
Compressor Icon (E):
It shows the condition of the cooling solenoid valve.
Icon off: Solenoid valve closed
Icon flashing: Delay timer on
Icon on: Solenoid valve open
5
S B C A & S C B F
figure 1
figure 2