Vollrath STOELTING SCBA118-37 Manual Del Propietário página 9

S B C A & S C B F
2 Use a suitable brush and wash all the parts in contact with
the beverage thoroughly with the detergent solution.
ATTENTION
While washing the dispenser, do not use excessive
amounts of water around the electrical components. This
could cause electric shocks or damage to the dispenser.
3 Wash the evaporator cylinders using a soft brush.
4 Rinse all washed parts under running water.
6. 4. 4 SANITIZING
Sanitizing must be done immediately before starting up the di-
spenser. Do not allow the dispenser to remain idle for a long
time after sanitation.
1 Before starting the procedures described below, wash your
hands with antibacterial soap.
2 Prepare 2 gallons of Stera-Sheen sanitizing solution
according to the manufacturer's instructions.
3 Immerse all parts to be sanitized in the solution for the time
indicated by the product manufacturer.
4 Dry the external parts of the dispenser without using
abrasive cloths.
6. 4. 5 REFITTING DOUBLE-WALLED BOWL
1 Place the right-hand part of the recover on a surface. Place
the container inside it.(see )(see figure 15).
figure 14
2 Put the left-hand part of the recover into position and make
sure that it fits into the illustrated groove. Click the two parts
together. (see figure 16)(see figure 17).
10
figure 15
figure 16
figure 17