To Start The Product - Husqvarna 225i Manual Del Usuario

must be large to engage the chain brake. If the chain
brake is too sensitive, it can engage during rough
operation.
• Will the chain brake always protect me from injury
during a kickback?
No. The chain brake must operate correctly to give
protection. The chain brake must also be engaged
during a kickback to stop the saw chain. If you are
near the guide bar, it is possible that the chain brake
does not have time to stop the saw chain before it
hits you.
WARNING:
working technique can prevent kickbacks.

To start the product

1. Do a check of the power trigger and power trigger
To do a check of the power trigger
lockout. Refer to
lockout on page 27 .
2. Engage the chain brake.
3. Put the battery in the battery holder.
CAUTION:
battery is installed correctly into the
battery holder. If the battery does not
move easily into the battery holder, the
position is not correct.
18
Only you and the correct
Make sure that the
4. Push on the lower part of the battery until you hear a
click sound.
5. Push and hold the start/stop button until the green
LED comes on.
To use the Boost function
The Boost function increases the chain speed and the
power of the product.
1. Push the Boost button. The green LED comes on.
2. Push the Boost button again to disconnect the
function. The green LED goes off.
1860 - 001 - 23.09.2022