Bullard XS Serie Manual De Instrucciones

PREPARING THE CHARGER FOR USE
USING THE XS CHARGER ON A TABLETOP
The XS Truckmount Charger can be used as a stand-alone
device on a tabletop. To use in this manner, install the
optional AC adapter as pictured in Figure 1.
INSTALLING THE XS CHARGER IN A VEHICLE:
Installation
The XS Charger is designed to be mounted on any convenient
flat-panel surface in a vehicle. When installed and used in
accordance with these instructions, the unit is designed to
comply with NFPA 1901-14.1.11.2 and EN1846-2
(see caution for proper installation).
Location
Select a conveniently located, flat-panel surface of sufficient size to
accommodate the unit. The unit can be mounted in any orientation
and will comply with NFPA 1901-14.1.11.2 and EN1846-2. The XS
Charger attaches through with five (5) #10 Hex Head Drilling Screws
that are also provided with the unit . Allow 6-inch clearance above the
charger to remove TXS.
NOTE
The XS Charger should be connected to an un-switched
fused circuit such as the apparatus battery that con-
tinues to provide power when the vehicle is not in use.
Wiring the XS Charger to a switched circuit or through
a relay may result in discharged imager batteries if the
vehicle is left idle for periods of more than a few days
at a time.
Item Requirements
Polarity
Red: Positive +
Black: Negative -
Input voltage 12V - 24V
Input current 2A @ 12V
Minimum gauge
18 AWG /
DO NOT wire the XS Charger to a third-party apparatus battery charger!
Failure to comply may result in improper function of the XS Charger.
ø
1 mm²
�
WARNING
BULLARD XS CHARGER
INSTRUCTION MANUAL
6 in/15 cm
w w w . b u l l a r d . c o m
6"
Figure 1
Figure 2
1