Bullard XS Serie Manual De Instrucciones página 3

REMOVING THE TXS FROM THE XS CHARGER
Pull down on the rubber strap until the rubber ball comes loose from
the hook, unfold the rubber strap and remove the camera from the
charger.
INSERTING THE SPARE RECHARGEABLE BATTERY INTO
THE XS CHARGER
The XS Charger charger is designed so that a spare battery, or second
camera can be recharged on the same unit. Set the battery firmly
into place in the XS Charger. Maintain the battery in position, fold
over the rubber strap and attach in place so that the rubber ball fits
into the hook.
CHARGING STATUS
The charger is automatically activated when an imager or battery is
inserted. Battery charge condition is indicated by the color of the light
emitted by the LEDs.
PULSING GREEN: Battery is charging
SOLID GREEN: Battery is fully charged
FLASHING ORANGE: Error condition (problem with the TI or charging
system).
�
EXPLOSION HAZARD. Do not connect or disconnect the equipment
to any charger in an hazardous location.
Do not short circuit, crush, incinerate, or disassemble.
Risk of fire, explosion, or burns.
�
Only Charge using Bullard XS charger, or Bullard provided USB plug.
�
Always use the correct charger and refer to the manufactuer's
instructions for proper charging instructions. Retain the original
product literature for future reference.
�
Battery Pack must be recycled or disposed of properly.
�
Battery Pack charging temperature 0˚C - 45˚C.
WARNING
WARNING
WARNING
WARNING
WARNING
w w w . b u l l a r d . c o m
BULLARD XS CHARGER
INSTRUCTION MANUAL
TROUBLESHOOTING
If you experience any problems with your TXS we refer to our website
(www.bullard.com/txs) for the latest information on fixes, updates,
and best practices.
RESET BUTTON
The reset button cuts the power of the charger, and is intended for
permanently wired setups. The reset button can be found at the base
of the charger. Reset (or briefly unplug) in case the charger signals an
error condition (flashing orange) or never ends the charge cycle. The
error condition may point to a temporary condition (such as overheat-
ing or a bad contact) or faulty battery or charger. In case of a regularly
repeated error condition or indefinite charge cycle, please contact
customer service (Figure 6).
REPLACING THE RUBBER STRAPS
The rubber straps are designed to be replaced. To replace the rubber straps,
unscrew with a Phillips or flathead screwdriver, pull out the hex head screw
and binding barrel, replace the strap, and reassemble (Figure 7).
�
The XS Charger is compliant with NFPA 1901-14.1.11.2 and EN1846-
2 and is able to be mounted in any orientation. Please use caution
when choosing a mounting location so that, if the camera is acciden-
tally dropped while being installed in the XS Charger, it will not injure
anyone nearby. For this reason, we do not recommend mounting the
XS Truckmount Charger on the ceiling of any vehicle. Use only a fused
power source of 2 amp capacity and 12-24 VDC voltage. Ensure that
the polarity of the power supply wiring is correct. Failure to follow these
instructions could result in serious injury or malfunction of the unit.
California Proposition 65
Cancer and Reproductive Harm- www.P65Warnings.ca.gov.
Figure 6
Reset Button
Figure 7
WARNING
�
WARNING
3